Remote Operation; Ieee-488 Interface Bus Connector; Gpib Address/Serial Communications Settings - Aeroflex Weinschel 8310 Operation & Service Manual

Model 8310

5. REMOTE OPERATION:

The following paragraphs provide setup and general guidelines for operating the Model 8310 using an
external controller.
5-1. IEEE-488 INTERFACE BUS CONNECTOR: Joining the Model 8310-1 to a system controller requires the
connection of IEEE-488 control bus cable to the IEEE-488 INTERFACE BUS connector located on the rear panel.
Figure 3 shows the connector's contact pin numbering scheme and lists the signal designator for signal present at
each contact pin.
PIN No.
5-2. GPIB ADDRESS/SERIAL COMMUNICATIONS SETTINGS: The GPIB Bus Address and Serial Communications
options are programmed via an internal 8 position DIP switch SW1 which is located on the rear panel. The switch is
shared between the two functions, with SW1-1 controlling the selection. When SW1-1 is OFF, the remaining switches
set the GPIB bus address. Likewise, when SW1-1 is ON, the switches are used to select the various serial options,
including baud rate, parity, and handshaking. Refer to Figure 4 for switch location.
Aeroflex / Weinschel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SIGNAL LINE
1 DIO 1
2 DIO 2
3 DIO 3
4 DIO 4
5 EOI (24)**
6 DAV
7 NRFD
8 NDAC
9 IFC
10 SRQ
11 ATN
12 SHIELD
* GND (N) refer to the signal ground return of the referenced pin.
** Return pin on pin 24.
Figure 3. IEEE-488 Interface Bus Pin Locations
PIN No. SIGNAL LINE
13 DIO 5
14 DIO 6
15 DIO 7
16 DIO 8
17 REN (24)**
18 GND (6)*
19 GND (7)*
20 GND (8)*
21 GND (9)*
22 GND (10)*
23 GND (11)*
24 GND, LOGIC
IM-289A
13