Advertisement
Quick Links
Advertisement
Summary of Contents for Laser 6803
- Page 1 Part No. 6803 Battery Tester 12 volt Instructions www.lasertools.co.uk...
-
Page 2: Technical Parameters
• Tests fully charged or partly discharged batteries Controls • Multi language • Test data can be printed out via PC or Laser 6804 Thermal Printer Battery Test Analyses battery health status to calculate actual cold cranking capability of the battery; advises whether to charge or replace battery if necessary. Can identify a faulty battery before actual failure. -
Page 3: Product Setup
Product Setup Product Setup Instrument can be powered up by (a) connecting to vehicle battery via the Select Language. crocodile clips (F), red to positive (+), black to negative (-), or (b) via the supplied USB cable to a PC. From the startup screen press the ENTER key (B) to display the main menu. - Page 4 Testing the Vehicle Battery Testing the Vehicle Battery Quick Test This test very quickly determines the battery status including voltage, CCA, electronic resistance, charge percentage value, state of health and test Good, but result. Recharge — current is low, From the startup screen press the ENTER key (B) to display the main menu. recharge before using.
- Page 5 Testing the Vehicle Battery Testing the Vehicle Battery Full Test — Battery in Vehicle Select battery type (info on battery label). Select 2.Battery in Vehicle from main menu. Now choose the measuring range for the battery; again, this information is displayed on the label on top of the battery.
- Page 6 Testing the Vehicle Battery Testing the Vehicle Battery If Cranking Test is Now select 2.Cranking Test abnormal, Replace from the Test in (battery) will be Vehicle menu. displayed with the results: The tester will now Now select prompt the operator 3.Charging Test to start the engine.
- Page 7 Testing the Vehicle Battery Testing the Vehicle Battery After the Ripple Test, the instrument will automatically start the Loaded After the test has been completed, the screen displays the effective Voltage Test: charging voltage and charging test results: The Loaded Voltage Test takes approximately 3 seconds, then you will be advised to bring the engine speed up to 2500 RPM and hold for 5 seconds.
-
Page 8: Print Data
Print Data Test — Battery Out of Vehicle The Laser 6803 Car Battery Tester can print out the test results via a PC or with the Laser 6804 Thermal Printer. Out of Vehicle means that the car battery is not connected to the vehicle’s electrical system, i.e. - Page 9 Print Data Print Data 5. When the PC confirms that the USB Driver software has been installed correctly, locate the Print Software folder. 8. On the main menu of the battery tester select 5.Print Data: 6. Run the print software. 9.
- Page 10 Precautions - please read • Only for use with automotive 12 volt systems. • Always refer to instructions before use. • Observe standard workshop safety procedures when using the tester. • Danger of sparking: (explosion risk) if vehicle battery has recently been charged, ensure area is well ventilated and ensure eye protection is worn before connecting up the battery tester.
- Page 11 Our products are designed to be used correctly and with care for the purpose for which they are intended. No liability is accepted by the Tool Connection for incorrect use of any of our products, and the Tool Connection cannot be held responsible for any damage to personnel, property or equipment when using the tools.