Advertisement
CONNECTING BAR FASTENERS
DRIVE SHAFT SEALING
6.1
6.2
Apply Silicone Sealant
(not supplied) to ends
of Connecting Bar
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
4
CYLINDER HARDWARE
NOTE: Loosen the Cylinder Flow Control Screw (Fig. C)
as needed to allow movement for Steps 5.1-5.2.
When finished with Cylinder Hardware, tighten the
Flow control Screw all the way closed then turn back
open 1½ turn.
CYLINDER ADJUSTMENT
Adjust the Cylinder Flow
Control Screw to allow
approximately 3 seconds
time for the ladder to glide
down when operating the
loaded Ladder Rack.
5.2
5.1
7
7
Advertisement
