Advertisement
Assembly Instructions
(con't)
Step 4
Align one Alternating Razer Teeth Row with 13
Teeth (D) on the Razer Drum (N) so that the two
outer holes on the teeth row align with two of the
outer holes on the drum. Insert a ¼" Hex Head
Screw (F) into each of the outer holes making sure
that the End Caps (O) are tight up against the
Razer Drum (N) when securing each fastener.
Each screw should be snug but not tightened
beyond the point where it makes contact with the
metal surface of each teeth row.
Step 5
Repeat the process for the next Alternating Teeth
Row with 12 Teeth (E) so that the hook of the teeth
points in the same direction as the first row, again
making sure that the End Caps (O) are tight up
against the Razer Drum (N) when installing the ¼"
Hex Head Screws. Continue in the same manner
alternating between the rows with 13 and 12 teeth
until all teeth rows have been installed and secured
in place. NOTE: The final row of teeth WILL NOT
be offset from first row.
Step 6
Slide one of the Handle Extensions (C) with the
spring clip into the Main Handle (B) by depressing
the buttons on the spring clip and sliding it in until
the holes align and the buttons lock into the holes
of the Main Handle.
Step 7
Repeat this process for the two remaining Handle
Extensions (C).
Step 8
Lastly, insert the Handle End Cap (P) on the last
Handle Extension to close off the tube.
4
www.weedrazers.com
Advertisement
