Advertisement
Notes:
Assembly Instructions
Tools Required:
• 10mm Wrench
• 11mm Wrench
Step 1
Insert a Carriage Bolt (G) into the inside of each
Drum End Cap (O) and thread on each Thrust
Bearing (J). Tighten each Thrust Bearing securely
using an adjustable end wrench.
Step 2
Next insert a Drum End Cap (O) into each end of
the Razer Drum (N), then install one Offset Handle
(A) onto each Carriage Bolt with the handles
forming a Y shape with the cylinder in the middle.
Next, slide the Main Handle (B) between the Offset
Handles so that the three holes align. Insert all
three Handle Bolts (M) and secure in place with
Handle Nuts (L) using a 11mm wrench. Tighten
the nuts only enough to prevent the handle from
wobbling; overtightening the nuts will bend the
handle and void the warranty.
Step 3
Install the Washers (I) and Lock Nuts (H) and
tighten each just enough so that the Carriage Bolt
protrudes slightly from the end of the Lock Nut.
Do not overtighten the nut, as the drum needs to
roll freely without resistance.
• Adjustable Wrench
• 1/4" Nut Driver
www.weedrazers.com
3
Advertisement
