Table of Contents
Advertisement
C. Programming the Double Quantity Pad — For multiple portion heating;
Your oven is factory set to automaticaliy double the programmed time for multiple portion heating — this is
the correct setting for heating multiple portions of most small foods items. No further programming of the
time is necessary for these food items.
The time required to heat multiple portions of some large platters and most bulk food loads is slightly less
than double that of a single portion.
This model incorporates a Multiple Portion Heating Custom Program feature that allows you to customize
the heating time and/or power level for multiple portions of your menu items.
For example, if Memory Pad 3 is set for 6 minutes at DEFROST, 12 minutes at DEFROST is set for double
quantity heating automatically. However, if your own tests have determined that the correct heating times
required is less (only 10 minutes 30 seconds at DEFROST) for two portions, the "Multiple Portion Heating
Custom Program" feature can be programmed for 10 minutes 30 seconds at DEFROST.
Example: To program 30 seconds at HIGH Power on Memory Pad Number 2 (display must be blank)
1.
PROG
rDOUBLE"
2
.
QUANTITY
POWER
4.
LEVEL
ZTDiEJ
5.
6 .
PROG
• Program the remaining Memory Pad as desired by repeating steps 1-6 above. (You may insert up to
NOTE:
10 memory programs.)
DO NOT OPEN THE OVEN DOOR during programming.
• When the
PROG
pressing
STOP/RESET
indicator is blinking, the program can be cancelled and/or the pad erased by
Pad.
•Press the
Pad.
PROG
NOTE:
•If no PROG Indicator appeared on
display, "Program Lock" should be
cancelled (see page 14).
•Do not keep pressing
more than 30 seconds, or a false
failure code may result.
•Press DOUBLE QUANTITY (x2) Pad.
•Press the Memory Pad 2.
The pad number and the previously
selected time and power level for
multiple portion heating will briefly
appear in the display.
•The pad number and Stage Heating
Indicator will reappear in the display.
•Press the
Power Level
once. The Memory Pad display will
go out.
•Press the Memory Pads 3, 0.
•Press the
Pad again. You
PROG
have completed programming the
selected Memory Pad for multiple
portion heating.
•2 seconds later, the setting for single
stage heating will appear in the display.
•2 seconds later, the display will go blank.
- 1 3 -
'•I'
■'' '*
Display Window
Pad for
PROG
40
Selector Pad
n
U
3 0
Advertisement
Table of Contents
