Advertisement
CP-EX Series
Installation Instructions
Surface Wall Mount
1. Install the (4) mounting feet to the back of the fixture. (Fig. 1)
2. Remove the (2) cover screws and set aside. (Fig. 2)
3. Swing down the cover assembly and the reflector plate. (Fig. 3)
4. Drill a 7/8" hole in the back of the fixture (see Fig. 2) for the AC supply
and/or remote load, making sure to avoid locations that would interfere
with the contents within the housing. Install the bushing (provided).
5. Mount the fixture to the mounting surface by fastening the mounting feet
using (4) fasteners (provided by others).
6. Make electrical connections; see Electrical Connections section.
7. Connect the battery to the PCB using the wire lead(s) from the positive
circuit board terminal (+) to the positive terminal connector on the battery.
Note: For large units, the battery/batteries may be shipped separate from
the housing. Install the battery/batteries into the housing and make the
appropriate battery connections.
8. If desired, remove appropriate chevrons. Chevrons are made of 2 layers
of self-adhesive vinyl. To remove, manuver a utility knife underneath the
desired chevron so that both layers of vinyl are penetrated. Carefully peel
the chevron away from the lens, working around the perimeter of the
chevron until fully removed. Remove the backing from the double sided
tape, align, then adhere the colored diffuser to the inside of the cover.
(Fig. 4)
9. Position the reflector and secure with ties.
10. Close cover and secure cover screws.
10070224 REV 1 - 07/20
Fig. 1
Cover
Screws
Fig. 2
Fig. 3
Reflector
Plate
Cover
Assembly
Fig. 4
2
Mounting
Feet
Magnetic
Test Switch
Drill Out
Hole in
Back of
Fixutre
Battery
800-533-3948 www.barronltg.com
Advertisement
