Traction Control Settings - Triumph Rocket 3 R Owner's Handbook Manual

General Information
If a fault occurs with the optimized
cornering traction control system, the
Traction Control (TC) disabled warning
light will illuminate and a message will
be shown in the display.
In this situation, the TC system will
continue to operate but without the
optimized cornering function, provided
that:
- There are no other faults with the TC
system.
- TC has NOT
the rider (see the Riding Modes
Configuration section)
Care must be taken when accelerating
and cornering on wet/slippery road
surfaces to avoid rear wheel spin.
In the event of a fault, the TC disabled
warning light may be accompanied
by the engine management system
malfunction indicator light and/or the
ABS warning light.
Do not continue to ride for longer than
is necessary with any of the above
warning lights illuminated. Contact an
authorized Triumph dealer as soon as
possible to have the fault checked and
rectified.
Hard acceleration and cornering in this
situation may cause the rear wheel
to spin resulting in loss of motorcycle
control and an accident.
Note
Optimized traction control may not
function if there is a malfunction with
the ABS system. In this situation, the
warning lights for the ABS, TC and the
MIL may be illuminated.
74
Warning
been disabled
Optimized cornering traction control
is a system designed to give the
rider increased
traction control be activated while the
motorcycle is leaning in a corner.
The system constantly monitors the
lean angle of the motorcycle and adapts
the level of traction control intervention
to maintain rear wheel traction during
cornering.
For full details of the TC disabled
warning
associated
messages, see page 27.
by

Traction Control Settings

If the traction control is disabled, the
motorcycle will handle as normal but
without traction control.
In this situation accelerating too hard
on wet/slippery road surfaces may
cause the rear wheel to slip, and may
result in loss of motorcycle control and
an accident.
The TC system can be disabled as
described in Bike Setup on page 46, or
set to the conditions described in Riding
Mode Configuration on page 43.
control
light operation
instrument
Warning
should the
and its
warning