Honeywell INTUVUE RDR-7000 Quick Start Manual page 5

1
WIRING
The RDR-7000 is designed to be a drop-in replacement for existing Primus radar
systems; no wiring changes should be required in this scenario. Updated installations
using Real-Beam Maritime and/or 3D Volumetric Buffer may require additional wiring.
NOTE
Refer to the full RDR-7000 installation manual and/or the appropriate STC for
instructions on how to complete the wiring.
2
FLAT PLATE INSTALLATION
a. Remove the FP-7000 and/or ART-7000 from their storage containers (if applicable).
b. Remove the sticker from the back of the Flat Plate.
c. Visually inspect and remove any debris.
d. Carefully position the FP-7000 on the ART-7000.
e. Engage the four captive screws (outer screws) to attach the FP-7000 to the ART-7000.
f. Engage the four captive screws (inner screws).
g. Torque the screws to 23 to 25 in-lb (2.6 to 2.8 Nm), starting with the inner screws.
NOTE
There will be approximately an eighth-inch gap between the antenna and the
ART-7000.
h. It is highly recommended to use a 9/64 ball-end hex driver (included), that allows off
angle driving of hardware.
Fig. 1. Flat Plate Installation