Chapter 4 Changing The Battery - Satec ezPAC SA300 Series Installation Manual

Chapter 4 Changing the Battery

4. Changing the Battery
When the battery level drops below the minimum allowed threshold, the red MEM.BAT.LOW LED on the
front of the device is lit up, indicating that the battery should be replaced. Use the following procedure:
1. Use a flat screwdriver to open the
battery compartment, turning
counter-clockwise.
2. Remove the battery cover and the battery
3. Replace the battery - with the plus towards the outside - and close the compartment.
IMPORTANT
Use an AA lithium 3.6 volt battery.
-
In order not to lose data stored in the memory, use PAS to upload data (see SA300
-
Operation Manual, Chapter 12) to a PC BEFORE changing the battery; OR, make sure you
change the battery while the power is ON. If you change the battery while power is off, you
will lose all data currently stored in the memory.
32
Chapter 4 Changing the Battery