Advertisement
Product Description
The Wall Pack series lights are the latest innovation from
Horner Lighting providing high output, while saving energy.
There are two models of Wall Packs: WWP and WWPC, both
coming in 40W and 60W options.
Precautions
WARNINGS
Risk of electrical shock. Disconnect power before servicing or
installing product.
Risque de choc électrique. Coupez l'alimentation avant
l'entretien ou l'installation du produit.
Risk of injury or damage. Unit will fall if not installed properly.
Follow installation instructions.
Risque de blessures ou de dommages. Unité va tomber s'il n'est
pas installé correctement. Suivez les instructions d'installation.
Risk of injury. Wear safety glasses and gloves during installation
and servicing.
Risque de blessure. Porter des lunettes de sécurité et des gants
lors de l'installation et de l'entretien.
Risk of injury or damage. LED light sources achieve full intensity
immediately after powered. Do not look directly the lights.
Risque de blessures ou de dommages. Sources de lumière LED
parvenir à pleine intensité immédiatement après sous tension. Ne
regardez pas directement la lumière.
Unit Installation
This guide is meant to be used for both the WWP and WWPC
models. Unpack the unit and check for any shipping damage.
NOTE: Wall Packs must match the input voltage to the supply
voltage. Please confirm the product voltage and supply
voltage match before installation.
WWPC40/
WWPC60
59 South State Ave., Indianapolis, IN 46201 | (p) 317.916.4274 (tf) 877.665.5666 (f) 317.639.4279 | www.hornerlighting.com
WALL PACK INSTALLATION GUIDE
Wall Pack Series Base
WWPC40/
WWPC60
WWP40/
WWP60
WWP40/
WWP60
LMAN0052-01-EN
Advertisement
Table of Contents
Related Manuals for HORNER WWPC40
Summary of Contents for HORNER WWPC40
- Page 1 WALL PACK INSTALLATION GUIDE Product Description The Wall Pack series lights are the latest innovation from Horner Lighting providing high output, while saving energy. There are two models of Wall Packs: WWP and WWPC, both coming in 40W and 60W options.
- Page 2 Fixture Mounting Mount the light base to the building using proper anchors for the building material. You may need to add additional support behind the surface material. Wiring Make all electrical connections in accordance with the National Electrical Code and any applicable local code requirements. Open back of unit housing to access Remove screw and lid to power Bring incoming AC through opening.
Need help?
Do you have a question about the WWPC40 and is the answer not in the manual?
Questions and answers