Advertisement
Camera Housing Assembly
1
Insert the battery pack
horizontally in (SLOT 2) and
route the cables through one
of the openings on either side.
Camera Housing Assembly
Note: Make sure the AA
batteries are fresh to assure
dependable results.
HOUSING BODY
SLOT 1
SLOT 2
STAINLESS STEEL
BRAIDED WIRE
( LINE TO REEL )
Preparing and Caring for Your Camera Housing
About the
Batteries
• Battery pack requires
standard 3 AA batteries. We
suggest Duracell
Optimum
®
or Energizer MAX
for the
®
longest life.
For any questions or concerns, please submit your inquiry from the contact form found on hookerelectric.com. GoPro® cameras and products is property of GoPro, Inc. Other brand names, products and services may be listed on this printed
material and in these instances, each brand name, product and/or service remains property of its respective owner. Hooker Electric, Inc. is not affiliated, sponsored or endorsed by the aforementioned brands.
©2020 Hooker Electric, Inc. All rights reserved. The Hooker Electric logo, girl and hook emblem is property of Hooker Electric, Inc. Fort Lauderdale, Florida USA.
2
Insert the contact into
(SLOT 1) so that the contact
is facing forward and the
power leads to the back of the
camera housing.
Testing Before
Each Use
• Make sure the threads and
o-ring on the camera housing's
lens and body are clean and
free from ANY DEBRIS.
• Assemble the lens to
the body and submerge in
water to check for any leaks
before inserting the internal
components (ie. battery, light
source, and camera.)
3
Insert your camera into
(SLOT 2) with the camera lens
facing forward. The battery
pack should fit snugly against
the back of your camera.
CONTACT
LIGHT BULB
BATTERY PACK
Cleaning and
Maintenance
• Clean the camera housing
body and lens with gentle
soap and clean water after
each use. Dry using a
microfiber cloth.
• Vaseline lubricant provided
for the o-ring, to help the seal.
• If you scratch the lens lightly,
it is repairable. You can send
it back to Hooker Electric for
refinishing.
• If you need a new wire or
mono installed on the housing,
send it back to us and we will
be happy to change it for you.
4
Slide the light bulb
facing forward into (SLOT 1)
so that the rear of the light
sits against the contact. The
light bulb should light-up upon
contact. Note: If light bulb
does not light-up, check the
AA batteries or if the leads are
firmly soldered.
CAMERA
Best GoPro
®
Settings
• Resolution setting
to 1080-30.
• View angle to 127 degrees.
• Turn all L.E.D.s on the
camera off.
• Set auto power to manual.
• Fits GoPro
models 6, 7,
®
8, and 9. Foam inserts are
included for smaller GoPro
®
models.
5
Carefully screw the lens
to the body. While holding the
housing body, tighten the lens
to medium hand pressure. DO
NOT over tighten or use tools
to tighten the lens as this may
cause damage to the unit.
LENS
250LB MONOFILAMENT
FISHING LINE
( LINE TO BAIT RIG )
Product
Warranty
The Hooker Electric Camera
Housing carries a 2-Year
warranty on manufacturer's
defect of the product but is
not responsible for any lost
camera housing, its' contents,
or other rigs or components
attached to it.
Advertisement
