TAGG Inferno User Manual

"Thank you for purchasing TAGG Inferno wireless earphones
with Bluetooth v.4.1 and echo elimination technology. Our
primary goal is to please you with superior sound quality and
comfort combined with convenience of hands free operation.
TAGG
Here is some useful piece of information that will help you operate
this earphone properly:"
--INFERNO--
USER'S MANUAL
Volume Button"-"/
Volume Button"+"/
Previous Song
Next Song
Power Button
USB Port
Speaker
FUNCTION OPERATION
Power ON Long press the HOME button for 3 secs
Long press the HOME button for 3 secs
Power OFF
Pairing Mode Blue and Red LED will start blinking
Connected
Blue LED will blink
Answer Call Short press the HOME button
End Calls Short press the HOME button
Change Track
Long press the Volume " +" & "-"
Volume "+" & "-" Press the "+" & "-" button
Mic Volume Press the "+" & "-" button while on call
Connecting with your device:
Keep your bluetooth device with in 3 Ft. while pairing.
Press the POWER button of TAGG inferno earphone for 3 secs.
Blue and Red LED will blink and earphone is in the pairing mode.
Now search for available bluetooth devices in your
Mobile/Laptop/iPad and select TAGG inferno from the list of
available devices.
If prompted, enter password or PIN required "0000".
If prompted by your mobile phone to connect, click "YES".
After successfully connecting Blue LED will flash twice after
every 4 secs.
How to charge:
LED
Connect to power using Micro USB.
To better protect the battery life, kindly use only the charging
cable provided with the earphone .
Allow 1-2 hours to completely charge the earphone.
LED Indications:
While charging - Red LED is On.
When completely charged there will be no light.
When battery is low, Red LED blinks every four seconds twice
and the voice prompt will let you know that battery status.
Pairing mode- Blue and Red LED starts flashing.
Reconnect the earphone:
If the connection is lost, TAGG inferno will try to reconnect
automatically.
If it does not reconnect, kindly press the POWER button for
3 secs and reconnect manually through your mobile bluetooth.
Common problems and solutions:
Mobile can't find the earphone:
Kindly restart your phone and the earphone.
There's always noise and the bluetooth keeps disconnecting:
The earphones needs to be charged.
Make sure you are not beyond the signal distance.
Bluetooth is connected but you are unable to listen to music:
Check your device setting to adjust the sound on hands free mode.
Some devices require you to select the device twice.
Some devices do not have complete stereo bluetooth,
kindly connect the earphone with another device to check if it is
functioning properly.
Bluetooth password:
"0000"
Maximum distance:
20 ft.
Red LED is not ON while charging:
This could be due to lack of use of earphone. It needs to be
charged for 30 min before the Red LED occurs.
Reset to factory setting:
When the Earphones are off, hold the power button for about ten
seconds until the red led flashes once- RESET.