Advertisement
For pools with a framework place K on the opposite sides of the frames, Place A and B on top of K
and secure one of the sides permanently. Then position the other side on top of K, to measure the
distance as previously mentioned.
4)
Note: The holes of the tubes P and Q should be facing towards the ends of both sides of the tube
system, so that the sides with the holes can be pushed onto the plug system of A and B.
5)
To connect the connections between R and P/ Q, fasten three screws of O into the pre-drilled holes of
R as shown. A minimum overlapping of 20 cm is required.
© by WilTec Wildanger Technik GmbH
Seite 5
http://www.WilTec.de
http://www.aoyue.eu
March 2020
Version
40
http://www.teichtip.de
Advertisement
