Table of Contents
Advertisement
QUICK-START INSTALLATION GUIDE
Decoder Setup
We recommend first configuring the Decoder on a test bench, as the output gain may need to be
adjusted via dipswitch. By default, output is 4 volts, and 5 ohms.
The following directions assume MPX Node is powered on and the web interface is still open.
1. Navigate to the µMPX Setup Page
2. Turn on the µMPX Decoder
3. Locate the Stream Receiver section, and set the default port to one that can pass through the
firewall on your network. If you have questions about this please consult the full user manual.
4. The meters should now show the incoming signal if the encoder is active.
a.
In the event you do not receive a stream, verify the encoder is turned on, and the IP
address and port number are correct.
5. Connect the composite output to your transmitter, or test equipment.
6. Verify your station is still modulating at 100%. If you are over modulating, navigate to µMPX
Setup menu, and use the MPX Level Output slider to adjust until you reach 100% modulation.
Want to know more?
In addition to familiarizing yourself with the various pages and controls in the GUI, we encourage
you to consult the full user manual, as it contains detailed information about how the MPX Node
functions. If you have questions user please do not hesitate to reach out to our support department
at support@telosalliance.com.
Advertisement
Table of Contents
