Page 1
The Omnia MPX Node is a purpose-built broadcast codec for transporting FM composite (MPX) signals over IP networks. This quick start guide provides the basic directions to configure your MPX Node. For more detailed information please consult the user manual, available at TelosAlliance.com/Omnia .
QUICK-START INSTALLATION GUIDE Initial Setup The MPX Node is predominantly controlled through an HTML5 web interface, so your first task is to get the unit connected to your network. For convenience, MPX Node ships set to DHCP for both network interfaces.
Page 3
1. Open a web browser on a computer connected to the same network as the MPX Node. 2. Type the IP Address of the MPX Node into the address bar of the web browser, and press enter. 3. When the Login page is presented the first time, the username and password are both “user”...
QUICK-START INSTALLATION GUIDE 4. After you log into the MPX Node for the first time you will be prompted to set a password. Note: The Password must be at least 6 characters long, and must contain at least 3 of the following: •...
Verifying operating mode There are two ways to confirm what operating mode your MPX Node is currently set to. In the web interface navigate to the “System Setup” page, and look in the upper left corner to see the operating mode.
Page 6
QUICK-START INSTALLATION GUIDE 3. Turn on the Encoder by clicking the On/Off button in the µMPX Encoder Settings section. 4. Set the bit rate you would like to transmit at (default is 320 kbps) 5. While feeding program audio from your processor, use the Main Input Level slider control to adjust appropriate input levels.
In addition to familiarizing yourself with the various pages and controls in the GUI, we encourage you to consult the full user manual, as it contains detailed information about how the MPX Node functions. If you have questions user please do not hesitate to reach out to our support department...