Confirming Startup Status; Default Vdom Configuration And Configuring The Management Interfaces - Fortinet FortiGate-6000F Series System Manual

Getting started with FortiGate-6000

Confirming startup status

Before verifying normal operation and making configuration changes and so on you should wait until the FortiGate-6000
is completely started up and synchronized. This can take a few minutes.
To confirm that the FortiGate-6000 is synchronized, go to
the management board (slot 0) all of the FPCs (slots 1 to 6 or 1 to 10) should be visible and their
In Sync . The Cluster Status monitor also indicates if any FPCs are not synchronized.
should be
You can also view the
that all power supplies and fans are operating normally.
From the CLI you can use the
synchronization status of the management board and FPCs. If all of the FPCs are synchronized, each output line should
include in_sync=1 . If a line ends with in_sync=0 , that FPC is not synchronized. The following example just shows a
few output lines:
diagnose sys confsync status | grep in_sy
FPC6KF3E17900200, Slave, uptime=5385.45, priority=119, slot_id=2:1, idx=2, flag=0x4, in_sync=1
F6KF313E17900031, Slave, uptime=5484.74, priority=2, slot_id=1:0, idx=0, flag=0x10, in_sync=1
F6KF313E17900032, Master, uptime=5488.57, priority=1, slot_id=2:0, idx=1, flag=0x10, in_sync=1
FPC6KF3E17900201, Slave, uptime=5388.78, priority=120, slot_id=2:2, idx=2, flag=0x4, in_sync=1
F6KF313E17900031, Slave, uptime=5484.74, priority=2, slot_id=1:0, idx=0, flag=0x10, in_sync=1
...
Default VDOM configuration and configuring the management
interfaces
By default, when you first start up a FortiGate-6000F it is operating in Multi VDOM mode. The default Multi VDOM
configuration includes the
ha1, and ha2 interfaces are in mgmt-vdom and all of the data interfaces are in the root VDOM.
You cannot delete or rename mgmt-vdom. You also cannot remove interfaces from it or add interfaces to it. You can
however, configure other settings such as routing required for management communication, interface IP addresses,
FortiGate-6000F 6.4.2 System Guide
Sensor Information dashboard widget to confirm that the system temperatures are normal and
diagnose sys confsync status | grep in_sy command to view the
root VDOM and a management VDOM named mgmt-vdom . The mgmt1, mgmt2, mgmt3,
Dashboard > Cluster Status . If the system is synchronized,
Fortinet Technologies Inc.
Configuration Status
31