Fortinet FortiGate-6000F Series System Manual page 24

FortiGate-6000F hardware assembly and rack mounting
Tabs, holes, and clips on the right inner rail
Lock out tab
Release tab
System release buttons
Attaching the inner rails to the FortiGate-6000F
Use the following steps to install the right inner rail and then repeat them for the left inner rail.
1. Remove the FortiGate-6000F from its packaging and place it on a flat surface.
For example, on a lifting device in front of the rack that it will be installed into.
2. Remove the right rail assembly from the packaging, and begin sliding the right inner rail out of it.
3. Unlock the right inner rail release tab to release the inner rail and slide it completely out of its rail assembly.
4. Locate the four rail hooks on the right side of the FortiGate-6000F and the corresponding holes on the inner rail.
5. Align the holes with the hooks and press the hooks into the holes to attach the right inner rail to the right side of the
FortiGate-6000F.
FortiGate-6000F 6.4.2 System Guide
Holes
Metal clip
Fortinet Technologies Inc.
Rail Hooks
Metal clip
24