Tune Into Stations - Aiwa RMD-99 ST User Manual

12
en

TUNE INTO STATIONS

Press the POWER ON/OFF button to turn on your radio, then select your desired band
by pressing the FM, AM, SW ( ) or ( ) button. Now, you can turn into your favorite
stations with any of the following tuning methods:
METHOD 1: ETM (EASY TUNING MODE)
ETM skillfully combines a reception circuit of high quality and high precision dial
for easy tuning radio stations.
Using ETM to auto tune and store all available stations into a temporary memory
without effecting ATS nor regular memories, please follow below steps:
1. Press the ETM button to
enter on Easy Tuning Mode.
The display will show the
word ETM.
2. Select your desired band by
pressing on the FM/AM/SW
button, then press and hold
the ETM button until the auto
scan starts.
The auto scan function will
store all the avalible stations
in the ETM memory.
3. When the auto scan has
stoped the searching, turn
the TUNING KNOB to select
those recently stored stations.
TIPS TO IMPROVE RECEPTION
A. For FM stations:
When you are in a different city or country, you should perform the ETM function again
instead of using ATS function, because this will not delete any of the stations already
stored within the memory.
B. For MW stations:
We highly recommend to perform the ETM function again during night time, as many
stations start broadcasting at night.
C.
For SW stations:
It is recommendable to perform the ETM function in the morning, afternoon as well as
night time, because the transmitting signal of SW is very unstable and usually there are
more stations that start broadcasting in the late afternoon.
Notes:
• While operating ETM to search for stations, a few stations might be missed if there
is interference in the surrounding. In this case, you can simply key-in the frequency,
then press the ETM button to manually store it into the ETM memory.
TUNE INTO STATIONS
METHOD 2: MANUAL TUNING
A.
Frequency searching:
Press the VF button to switch into
frequency mode, and then rotate
the TUNING KNOB knob to select
your desired station.
B. Memory searching:
Press the VM button to switch into memory mode, and then rotate the TUNING KNOB
to select those stored stations.
METHOD 3: AUTO BROWSE STATIONS
1. Turn on the radio and press
the VF button to switch into
frequency mode.
Press and hold the VF button
2.
until the FAST TUNING speed
mode " " starts scanning
from one station to another,
staying on each station for
about 5 seconds.
3. To stop the auto browse
function, simply press the VF
button again.
METHOD 4: DIRECT KEYPAD ENTRY
To search for a frequency, turn on the radio and press the VF button to switch into
frequency mode, press the numeric keys 0-9 to enter the station frequency directly.
To search for those stored stations, press the VM button to switch into memory
mode, then press the numeric keys 0-9 to enter the preset memory number directly.
Notes:
• While operating the Auto-browse Station function, you can press the M button
anytime to store the current station in the memory; the unit will keep on auto
browsing the next available station afterwards.
• Ignore the decimal point for FM band when inputting the frequency numbers.
For example, FM 89.3 MHz, just enter 8 9 3.
• If the entered frequency is not within the covering area,the display will show the
"Err" (error) symbol.
13