Advertisement
Card Installation
Follow these steps to install the SCSI/VGA combo card.
1.
Remove a bracket cover opposite an empty PCI slot.
2.
Position the card over the PCI slot, then insert the card golden
fingers into the slot until the card fits in place.
3.
Secure the card with a screw.
4.
Connect the LED cable to the system board's SCSI LED connector
(please refer to the system board user's manual for the location of
this connector) and then to the LED connector (CN5) on the combo
card.
Figure 1-2
Installing the SCSI/VGA Combo Card
SCSI/VGA Combo Card
9
Advertisement
