Bill Dispenser Settings (Bx Model); Bill Dispenser Model; Cassette Value; Cassette Type - Standard Change-Makers Guardian GXP Operating Instructions Manual

5.14 Bill Dispenser Settings (BX model)

This menu should only be used if you have a bill dispenser connected to the control board at
connector J8. If you make a change to the bill dispenser model or value of the cassette it will be
necessary that you reset the control board before these changes can take affect in the rest of
programming.
Note: Cassette one is at the top of the bill dispenser.
The following setup procedure applies to version 3.040 and higher of the Controller (EFII)
Module

5.14.1 Bill Dispenser Model

dispenser model
¬ ®
none
· none – A bill dispenser is not connected
· F50 (1) cassette – A Fujitsu model F50 bill dispenser is connected. This model only has one
cassette.
· F53 (2) cassette – A Fujitsu model F53 bill dispenser is connected with two cassettes.
· F53 (3) cassette – A Fujitsu model F53 bill dispenser is connected with three cassettes.
· F53 (4) cassette – A Fujitsu model F53 bill dispenser is connected with four cassettes.

5.14.2 Cassette Value

cassette 1
value $0.00
Enter the value of the coupon or bill loaded in the cassette.

5.14.3 Cassette Type

cassette 1 type
¬ ®
bill
· bill
· coupon
Multiple choice between bills and coupons.

5.14.4 Cassette Low Count

cassette low count
30
Enter the number of bills or coupons that can be dispensed past a sold out condition. Do not set this
count too high as it will allow the dispenser to run empty which could result in a short pay to the user
if the machine cannot transfer the unpaid balance to another dispenser. This applies to all of the
cassettes.
68