Table of Contents
Advertisement
4.
Attach the power cable, the SCSI terminator, the HDD fault LED cable,
and the system board connector cable to the backplane board and attach
the other end of the connector cable to the system board.
location of the SCSI connector, please refer to the system board manual.
Single Hot-swap Cage Configuration
Power connector
SCSI Terminator
There are two kinds of HDD Fault LED cable
supplied.
should be use with AcerAltos 1100 and AcerAltos
11000 systems.
Station 7000.
IDM Housing
System board
connector cable
CN3: Connect to system
board's HDD Fault LED
The cable with two 4-pin connector
The other cable with AcerPro
For the
11
Advertisement
Table of Contents
