Reconfiguring The System; Ide Hard Disk Support - Acer M1A User Manual

1.4.5

Reconfiguring the System

You must enter Setup after installing or removing SIMMs to
reconfigure the system.
Follow these steps to reconfigure the system:
1. Turn the system on.
indicating that the total memory does not match the value stored

in CMOS.
2. Press  + +
appears indicating an incorrect memory configuration.
3. Press twice to exit and reboot the system.
The system boots with the new memory configuration.
1.5

IDE Hard Disk Support

The system board supports four IDE hard disks, or any other IDE
devices, through the two onboard Enhanced IDE interfaces.
Figure 1-3 for the location of the interfaces.
Follow the instructions in the housing installation manual on how to
install a hard disk in the system. Connect the cables according to the
IDE hard disk configuration in Table 1-4.
Table 1-4 IDE Hard Disk Configuration
IDE Connector
Channel 1
Channel 2
System Board
A memory error message appears,

to enter Setup.
Master
Hard disk 0 Hard disk 1
Hard disk 2 Hard disk 3
A warning message
See
Slave
1-13