Reconfiguring The System - Acer 900 User Manual

1.7.5

Reconfiguring the System

Reconfigure the system after installing or removing SIMMs.
Follow these steps to reconfigure the system:
1. Reboot the system.
indicating that the total memory does not match the value stored
in CMOS.
2. Press +
routine to run Setup.
wrong memory configuration appears.
3. Press twice to exit Setup and reboot the system.
system boots with the new memory configuration.
If you operate the system with WindowsNT,
NetWare, or UnixWare, make sure to run
ECU every time you install or remove an
EISA or a non-PnP ISA card. See Chapter 3
for information on ECU.
1-16
A memory error message appears,
+ during the power-on self-test (POST)
During POST, a message indicating a
The
User's Guide