Poly VVX Series User Manual

The Poly VVX Series telephones are compatible with Poly (formerly Plantronics) CS500 and Savi Series headsets. A Telephone Interface
Cable is included with the headset for connecting the telephone; however, using this standard cable requires the end user to press the
headset key on the telephone to answer and end calls. A Headset Hands-Free Adapter is available separately from POPP to enable the
answering/ending of calls from the headset only.
Pictured: CS530
With Headset Hands-Free
Adapter:
(sold separately)
Pictured: CS530
With Plantronics
Telephone Interface Cable:
(included in headset box)
© POPP.com, Inc. All rights reserved.
Poly VVX with CS500 and Savi Series Headset User Guide
Connecting and using the headset with and without the Hands Free Adapter Cable
Connecting the CS500 or Savi Series Headset to a Poly VVX Series Telephone
1. Connect the Headset Hands-Free Adapter to the headset base unit and to the Poly telephone as
shown below.
2. IMPORTANT: Configure the Poly telephone for the Hands-Free Adapter
On the telephone, press the Home key, then select 'Settings' → 'Basic' → 'Preferences' →
'Headset' → 'Hookswitch Mode'. Select 'Plantronics EHS...'. When the "Reboot Phone – Are You
Sure?" prompt appears – select 'Yes'.
1. Connect the Telephone Interface Cable to the headset base unit and to the Poly telephone as
shown below. No further configuration of the Poly telephone is necessary.
Large Connector
Small Connector
For service, call 763-797-7900 or visit www.popp.com
Pictured: CS530 Base Unit
Pictured: Poly VVX Series Telephone
Pictured: CS530 Base Unit
Pictured: Poly VVX Series Telephone
Page 1 of 3 4/1/21