Kato 2KRE Series Instructions For Using

TOOL MAINTENANCE
Installation tools should be periodically inspected for damage or wear. Tools should be kept clean so
that foreign objects and debris (chips, oils, and dirt) will not clog the tool and prevent the Pawl from
fully pivoting inside the Mandrel. Operator misuse can contribute to premature wear and/or damage
to the Pawl or Mandrel.
PARTS REPLACEMENT
Replacement Pawls, Pawl Kits (includes 1 Pawl, 2 Pins, and 2 Springs), and replacement Mandrels
are available from KATO (see Parts List below).
FOLLOW THE PROCEDURES BELOW TO REPLACE A DAMAGED PAWL OR MANDREL.
1. Loosen the Lock Nut.
2. Remove the Lock Nut and Adjusting Sleeve from the Mandrel.
3. Push out the Pawl Pin (see figure 1). Be careful not to lose the Pin.
4. Remove the Pawl from the Mandrel slot.
5. Remove the Spring from the Mandrel. Be careful not to lose the Spring.
TO REASSEMBLE:
6. Insert the Spring into the Mandrel. (The Spring goes into the hole closest to the Pawl Pin)
7. Insert the Pawl into the Mandrel Slot.
8. Line up the Pin holes (Pawl & Mandrel) and press in the Pin.
9. Check for spring action and free movement of the Pawl in the Mandrel slot.
10. Thread the Lock Nut and Adjusting Sleeve back into the Mandrel.
SAFETY
Always wear eye protection when working with KATO tools.
FOR ASSISTANCE CONTACT THE KATO TECH GROUP AT
Phone: (757) 873-8980
Email: support@katofastening.com
or, visit us online www.katofastening.com
PARTS LIST
REPLACEMENT PARTS
Pawl
Pawl Kit
Replacement Mandrel
Adjusting Sleeve Housing (Nylon Guard not included)
Nylon Guard
X-XX Signifies Thread Type & Size Designation. For example, 2KREC-04M
Page 4
INSTRUCTIONS FOR USING KATO TANGLESS
KATO PART NUMBER
2KIPX-XX
2KIPX-XXK
2KREX-XXM
2KREX-XXH
2KREX-XXG
 2019 KATO Fastening Systems, Inc.
THE FOLLOWING INSTRUCTIONS ARE APPLICABLE TO THE
KATO TANGLESS ROUND ELECTRIC INSTALLATION TOOL (2KRE Series)
® COILTHREAD ® INSERT TOOLS
Page 1