Gprs Function; Microphone Function - Hunter APP-100 Manual

SEND SMS
DEVICE REPLY
SEND SMS
DEVICE REPLY
SEND SMS TO GET MULTIPLE LOCATIONS
DEVICE REPLY
DEVICE SENDS
Device will make a call to Authorize number, you accept the call and you can hear the sound from device microphone.
If device is in area without GSM signal the messages will storage in device memory up to 1024 messages (with coordinates) and
sending to authorized number once the device registered again to GSM network user can stop/play/erase the stored messages
with the following commands
FACID,123456,STOREDMSG,ERASE;
FACID,123456,STOREDMSG,PLAY;
FACID,123456,STOREDMSG,STOP;
FACID,123456,STOREDMSG,COUNT;
**Device start play all the stored messages by it self once get GSM signal
Use the GPS tracker in an open area.
Hold the magnet for 1 sec near the LED in order to turn the tracker on. Then, remove the magnet. Now, the GPS tracker is activated. The
to be synchronized with the GPS satellites.
Now, the GPS tracker is deactivated.
The GPS tracker is always on power save mode function. If the device is not moving, it stops sending any info to the mobile; this happens
This function ensures longer battery life (max 300 hours).
WHEN THE DEVICE GOES TO POWER SAVE MODE
1 IF THE DEVICE DOES NOT MOVE FOR 120 SECONDS
2 IF IT DOES NOT RECEIVE SMS, MISSED CALL OR DATA
3 IF NO ALARM TRANSMITTION IS PENDING
The tracker should be charged while is switched on. Hold the magnet for 1 sec near the LED in order to turn the tracker on. Then, remove
charged the red LED is on continuously. After charging is complete, disconnect the charger and lower down the orange protective cover.
activated.
The battery autonomy is max 400 hours, depending on the setting of the auto report function.

GPRS FUNCTION

FACID,123456,AUTHORIZE,1=+(COUNTRY CODE PHONE NO);
FACID authorize ok! 5 nums updated
FACID,123456,GPRS,ADDR=5.189.191.57,PORT=5024,NAME=USER
NAME,PASS=PASSWORD,APN=APN,MODE=0;
FACID GPRS ,OK!
FACID,123456,LOC,I=240,T=04;
FACID,123456,LOC,I=60,T=999;
FACID loc ok! I=60, T=999

MICROPHONE FUNCTION

SEND SMS: FACID,123456,CALLBACK;
STORAGE POINTS FUNCTION
erase all the messages
starts playback and delays PSM until all played
stop playback and allows PSM
gets count of how many messages saved
*PSM=Power Save Mode
Tracker Activation / Deactivation
Power Save Mode
Tracker charging
Copyright by Hunter Electronics Limited. All Rights Reserved