Adding Extra Covr Points To Expand Your Whole Home Wi-Fi; Led Indicator Status; Technical Support - D-Link COVR Simple Setup Manual

Adding extra Covr Points to expand your whole home Wi-Fi:

Connect and plug in the new Covr Point
1
close to any of your existing Covr Points and
wait for it to boot up.
When the Covr LED is blinking amber, use an
Ethernet cable to connect the new Covr Point to
the existing Covr Point. When the Covr LED on
2
the new Covr Point turns solid white, the new
Covr Point is paired and will reboot itself to
complete the setup process.
Disconnect the Ethernet cable and place the
3
new Covr Point anywhere in your home to
extend your whole home Wi-Fi.
Check the LED indicator on your Covr Points
to ensure proper connection.
Solid white: Strong signal.
Blinking white: Weak signal. Move
your Covr Point closer to Covr Point
A until the LED turns solid white.
Blinking orange: No signal. Move your
Covr Point closer to Covr Point A
until the LED turns solid white.
Having trouble installing your new product? D-Link's website contains the latest user documentation and
software updates for D-Link products. Australian and New Zealand customers can contact D-Link Technical
Support through our website.
Australia:
Tel: 1300-700-100

24/7 Technical Support

Web: http://www.dlink.com.au
E-mail: support@dlink.com.au
TECHNICAL SUPPORT
New Zealand:
Tel: 0800-900-900
24/7 Technical Support
Web: http://www.dlink.co.nz
E-mail: support@dlink.co.nz
Version 1.00(AU)_130x180 | 2019/01/22