TABLE OF CONTENTS REGULATIONS AND SECURITY SAFETY INSTRUCTIONS SYSTEM DESCRIPTION INSTALLATION INSTRUCTIONS POWER AND CONTROL CONTROLS AHnet PROTOCOLS AHlink INFORMATION ON DISPOSAL WARRANTY TERMS AND CONDITIONS...
Page 4
WELCOME Thank you very much for purchasing an Arthur Holm product. Please, read these installation and operating instructions carefully and keep them in a safe place for future consultations. We remain at your entire disposal if you have any suggestions.
Page 5
ABOUT US The Company Arthur Holm has its origins in the Danish furniture designer Jorgen Alex Jensen, who was active during the sixties and the seventies. His design inspiration and his concept of ergonomics have been continued by his family, who is the design force behind Arthur Holm product range. The...
EC REGULATIONS AND SECURITY ATTENTION: Do not disassemble or modify the device in any way. This symbol warns of the presence of dangerous un-insulated voltages inside some of the components, of sufficient magnitude to expose people to risk of electronic shock. This symbol draws attention to important use and maintenance instructions in the manual that accompanies the unit.
Page 7
SAFETY INSTRUCTIONS Wiring connected to hazardous voltage requires installation by qualified personnel or the use of ready-made flexible cables. For your security, your equipment must be connected to an elec- trical outlet with grounding connection protection. Since the plug is used to disconnect the device, the operating electrical outlet must be in an easily accessible place.
SYSTEM DESCRIPTION General The CourtesyBox is an outstanding motorised solution to hide different items in the tables, keeping a clean surface. Expect the unexpected with the CourtesyBox for water and glasses or as a tissue box. The CourtesyBox can be controlled locally or remotely through R422 and the open/close button can be disabled or locked.
Page 9
SYSTEM DESCRIPTION Available Models MODEL DESCRIPTION Motorised enclosure for bottles and glasses. Brushed stainless steel cover plate with a push button for open AHCBB and close and Control: AHnet, RS-422, AHlink. Motorised enclosure for tissues. Brushed stainless steel cover plate with a push button for open and close and AHCBT Controls: AHnet, RS-422, AHlink.
INSTALLATION INSTRUCTIONS Assembly Guide for UniversalCourtesyBox Brackets Insert the UniversalCourtesyBox through the table hole and joint the screws. Screw the four M6x50 screws to fix the device with the table. Tighten them just to apply a light pressure against the table.
POWER AND CONTROL AHnet: RJ45 CAT5 connector for addressable RS422 control. There is a loop through connector to use as signal RS422 output. You can connect up to 30 devices on the same RS422 bus Termination: Active (ON) the termination ONLY on the last devices of the RS422 bus ADDRESS: Configure the AHnet unit address on RS422 bus to individually control the unit using RS422 AHnet protocol...
AHnet PROTOCOL Communications protocol Speed and configuration BAUD RATE 38400 COMMUNICATION RS422 DATA BITS CONNECTION RJ45 PARITY NONE WIRING CAT-6 STOP BITS Wiring Diagram 1. Data TX + 2. Data TX – 3. Data RX + 4. NC 5. NC 6 .Data RX RJ-45 7.
Page 13
AHnet PROTOCOL Commands COMMAND DESCRIPTION RESPONSE OPEN THE UNIT FA XX 01 01 00 FB XX 01 01 00 CLOSE THE UNIT FA XX 01 00 00 FB XX 01 00 00 BUTTON LOCK FA XX 04 01 00 FB XX 04 01 00 BUTTON UNLOCK FA XX 04 00 00 FB XX 04 00 00...
AHlink AHlink is used to control and set-up the unit. By default, the AHLink wireless signal is deactivated. To activate it, please press and hold the Open/Close (1) button on the cover plate for 5 seconds. The wireless AHLink signal automatically deactivates when there is no device connected during more than 2 minutes.
Page 15
AHlink If your AH device does not appear screen, AHLink signal might no longer be active. The AHLink name always begins with characters “AH” followed by the four last MAC AHLink address. You must select the AH device. After selecting the AH device, the first page will upload on your screen.
Page 16
AHlink The first line shows the model name of the device. SERIAL Serial number of the unit Firmware version Controls the Open and Close of the hatch COMMAND: Information of the last AHnet command received from RS422 port SENSORS: Indicates sensor status. S1: CLOSED POSITION S2: OPEN POSITION AHNET ADDRESS...
INFORMATION ON DISPOSAL FOR USERS OF WASTE ELECTRICAL & ELECTRONIC EQUIPMENT This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to the designated collection points, where they will be accepted on a free of charge basis.
WARRANTY TERMS AND CONDITIONS Albiral Display Solutions warrants this product against manufacturing defects and workmanship for a period of two (2) years from the date of purchase, subject to the conditions below. Electrical, electronic boards, engine, mechanical parts, accessories and power supply are warranted against manufacturing defects and workmanship for a period of two (2) years from the date ot purchase.