superbrightleds PLLD2 Series User Manual

Important: Read all instructions prior to installation.
LED Parking Lot/Area Light
PLLD2-50K300-H3-HV (with PLLD2-SF)

Specifications

Environmental Specifications
Operating Temperature
IP Rating

Mounting Options

Slip-Fitter Knuckle Mount (PLLD2-SF)
Trunnion Wall/Surface Mount (PLLD2-WM)
-40°–122° F(-40°–50° C)
IP65
Pole/Post Knuckle Mount (PLLD2-APM)
Fixed Pole/Post Mount (PLLD2-FPM)

Safety and Notes

• Product should be installed and serviced by a certified electrician
in accordance with applicable national, state, and local building
and electrical codes.
• To reduce the risk of electric shock, ensure that the main power
source and circuit breakers are switched off before performing
any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the
weight of the fixture. Failure to properly support fixture may
result in damage or injury, for which the manufacturer does not
assume responsibility.
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.

Lens Removal and Installation

Note: make certain to keep the light away from excess dust
and moisture during this process.
1. Remove screws around perimeter of lens.
2. Gently pry lens from light.
3. Install new lens and securely tighten all screws.
Rev Date: V2.0 12/06/2019
4400 Earth City Expy, St. Louis, MO 63045
User Manual
PLLD2 Series
866-590-3533 superbrightleds.com