Advertisement
4.TopGun & RF receiver Installation
4.1 Set the channel of the RF receiver to either 1 or 2 (refer to the picture below), and set the TopGun to the
corresponding channel.
4.2 For PS2™/PS3™, please turn ON the console and load a "GunCon2™ compatible" game first. When the game demo
screen appear, plug in RF receiver. For PC, please simply plug in the RF receiver to USB port. PC would then ask
for the driver. Please refer to (5) Install the driver to install the driver.
Note : normally, the LED on the receiver will keep lighting, which only indicates that the receiver is functioning.
4.3 Insert two AA battery into the TopGun handle in the right direction, according to the picture below.
4.4 Turn ON the switch (ON/OFF) of the TopGun, and the "POWER" LED above will light.
* In case battery is low, the "LOW POWER" LED beside it will light at the same time.
4.5 After turn ON the TopGun and plug in the RF receiver, the LED on the receiver will keep flashing.
If it doesn't flash, that means the gun could not communicate with the receiver. This may be the
problem of wrong channel setting. Please double check if the channel of the TopGun and the RF
receiver are the same.
Note : 1. At most two TopGun could be connected to the same console.
2. No matter single TopGun or dual TopGun installation, only one pair of LED stands is needed for one screen.
3. To install two TopGun, user must set the two TopGun and the two RF receiver to different channels.
4. The range of RF receiver is 7m. In this range, two TopGun of the same channel will interrupt each other.
5. Other 2.4G Hz wireless device may interrupt the TopGun.
6. For the first time to install TopGun on PC, PC would ask for the driver. Please refer to (5) Install the driver
to install the driver.
Advertisement
