To Sanitise With Your Steam Mop - Shark S1000EU Instructions Manual

USING YOUR STEAM MOP - CONT.
Fig. 1
Pull and twist the quick release cord holder to
1
unwrap the power cord completely (Fig. 1). When
Steam Mop is plugged into an electrical socket,
the power light will illuminate (Fig. 2). It takes
approximately 30 seconds for the mop to heat up
and the steam to be ready.
2 Pump the handle a few times in a downward
motion (Fig. 3) This pumping action will release
steam as you mop and allows you to customise the
amount of steam you want. Begin mopping with a
forward and backward motion. The natural motion
of mopping will produce steam.
3 When the water tank is empty, the Steam Mop will
stop producing steam. Make sure to unplug the
Steam Mop before refilling the water tank. Follow
the water tank refilling instructions on pages 7-8.
38
0800 000 9063
Fig. 2
Fig. 3
TO SANITISE* WITH YOUR STEAM MOP
1 Start with a clean pad.
2 Pump the handle a few times in a downward motion (Fig. 1).
3 Start mopping on an appropriate sealed hard-floor surface with a forward and
backward motion. After three minutes, your unit is ready to be used to sanitise.
4 Using a forward and backward motion, move the unit over the area you seek to
sanitise. Repeat at least 15 times.
*Sanitisation studies were conducted under controlled test
conditions. Household conditions and results may vary.
Fig. 1
39
s h a r kc l e a n . e u