Manual Steam Control - Shark KLIK N' FLIP S6001EU Owner's Manual

Manual Steam Control

SETTING
Laminate
Hardwood
MANUAL
Marble
Tile
Stone
For an extra burst of steam, you can use the Steam Blaster. Follow the instructions found on
Steam Blaster
™
the "Using your Steam Pocket
TO SANITIZE* WITH THE STEAM MOP USING THE KLIK N' FLIP MOP HEAD AND THE DIRT GRIP
1
Attach a clean Dirt Grip pad to the Klik N' Flip Mop Head.
2
Plug into an electrical outlet. The blue light will illuminate. It takes approximately 30 seconds for the mop to heat up
and the steam to be ready.
3
Pump the handle a few times in a downward motion. This pumping action will release steam as you Steam Mop,
and allows you to customize the amount of steam you want.
4
Start mopping on an appropriate sealed hard-floor surface with a forward and backward motion. After three minutes,
your unit is ready to be used to sanitize.
5
Using a forward and backward motion, move the unit over the area you seek to sanitize. Repeat at least 3 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary.
Klik N' Flip Mop Head only when used with Steam Mop. Not in Steam Blaster
IDEAL FOR THESE SEALED
SURFACES
RECOMMENDED USAGE
Cleaning sealed surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate and heavy traffic areas
Mop" page.
®
PAD:
™
mode.
™
www.sharkclean.eu 33