Working Hints For Your Mixer; Troubleshooting - Wickes PDN122 Manual

3. VARIABLE SPEED CONTROL (See Fig. C)
The variable speed control (5) allows you to vary the
speed of the mixer. The speed increases as you turn
the switch towards high speed symbol direction and
decreases for the low speed symbol direction. Just turn
variable speed control to adjust speed.
4. HAND GRIP AREAS
Always hold your tool firmly with both hands when operating and take a secure stance.

WORKING HINTS FOR YOUR MIXER

1. Keep connection nut clean, and apply some lubrication on thread when you install the mixing paddle (1).
2. Guide the machine through the mixing vessel. Continue mixing the material until it is fully homogenized.
3. When you insert the mixer into the material to be mixed or take it out, reduce the speed.
4. When you have finished the mixing work, clean the mixer.
5. If your power tool becomes hot, set the speed to maximum and run with no load for 2-3 minutes to cool the motor.

TROUBLESHOOTING

1. If your power tool does not start, check the plug on the power supply first.
2. If there is difficulty loosening the mixing paddle (1), apply lubrication.
3. If a fault can not be rectified, return the tool to an authorized dealer for repair.
Fig. C
9