used for appropriate conditions will reduce personal inju- Safety Notes ries. Prevent unintentional starting. Ensure the switch is in General Power Tool Safety Warnings the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Read all safety warnings and all in- WARNING structions.
Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and Technical Data lead to loss of control over the power tool. TH308266-6 TH308266-8 TH308266S Model No. TH308266 (ISRSEL Plug)
Assembly Before any work on the machine itself, Adjusting the Drilling Depth pull the mains plug. The required drilling depth can be set with the depth stop Auxiliary Handle –Press the button for the depth stop adjustment 9 and in- Operate your machine only with the sert the depth stop into the auxiliary handle 11.
Operation Light pressure on the On/Off switch 6 results in low speed/im- pact rate. Further pressure on the switch increases the Starting Operation speed/impact rate. Observe correct mains voltage! The voltage of the pow- er source must agree with the voltage specified on the Safety Clutch nameplate of the machine.
Page 9
TH308266,UTH308266, TH308266-6,TH308266-8,TH308266S Spare part list Part Description Part Description Part Description BALL BEARING PROTECTION SLEEVE Assembly STRAIGHT PIN SHIM RING PROTECTIVE CAP CATCH DISC SPRING WASHER DISC SNAP RING SCREW SNAP RING CYLINDER ARMATURE Assembly RETAINING RING GUIDE BUSHING 16.1...
Need help?
Do you have a question about the TH308266 and is the answer not in the manual?
Questions and answers