Sony DSX-GS900 Service Manual page 7

DSX-GS900
4. The setting is completed by pressing the [PUSH ENTER/
MENU/ VOICE] button on the main unit or [ENTER] but-
ton on the remote commander at the state of cursor position of
"OP0", then the display turns off, the initialization operation is
done, and the display returns to the clock display.
[PUSH ENTER/MENU/
VOICE] press
5. Complete the destination setting work and perform "CONFIR-
MATION OF DESTINATION SETTING CODE" on page 5
again to check the destination code.
7
or
cursor position
[ENTER] press
of OP0
INITIALIZATION METHOD
Refer to the following procedure when initializing this unit.
When this unit is initialized, the clock settings and some saved con-
tents can be deleted.
Note 1: After this unit has been repaired, perform this unit initialization
before installing this unit in the car.
Note 2: After performing a BLUETOOTH connection, be sure to initial-
ize this unit and clear the connection history.
Initialization procedure:
1. Connect the power cord to the regulated DC power supply, and
turn the power on of this unit.
2. Press and hold the [ OFF SRC] button to the state of source off
(the clock is displayed on the liquid crystal display).
3. Press the [PUSH ENTER MENU/ VOICE] button, and rotate
the control dial to display the "GENERAL". Then press the
[PUSH ENTER MENU/ VOICE] button again.
(Displayed characters/values in the following fi gure are exam-
ple)
4. Rotate the control dial to display the "INITIALIZE" and press
the [PUSH ENTER MENU/ VOICE] button.
Sony CONFIDENTIAL
For Authorized Servicer
+
–
Regulated DC
power supply
– Continued on next page –
SYS SET