Table of Contents
Advertisement
•
Make sure that the distance between the bottom of the heater and the floor is not less than 20
cm when the heater is installed.
Commissioning
To put the heater into operation, please follow the instructions below:
1. Check the heater to make sure it is not damaged.
2. Plug in the plug and switch on the device at the illu-
minated on/ off switch.
3. If you do not want to heat the room, switch off the
heating.
4. If you do not use the heater for a longer period of
time, remove the plug from the outlet.
Parts of the Control Unit
1.
On/off switch
2.
Control panel
3.
Radiator
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 60259-60262
Seite 5
11
2020-1
Advertisement
Table of Contents
