Table of Contents
Advertisement
•
Do not operate the heater with a damaged cable, plug or after other malfunctions have occurred,
the heater has been dropped or damaged otherwise. Take it to a qualified technician for inspec-
tion, electrical/ mechanical adjustment or repair.
•
For indoor use only. For wall mounting only. Do not use outside.
•
This heater is not intended for use in bathrooms, laundry rooms and similar indoor areas. Never
position the heater so that it can fall into the bathtub or other water containers.
•
Do not place the power cord under any materials. Do not cover the power cord with rugs, run-
ners, or similar covers. Do not operate the heater after malfunctions have occurred. Do not
operate the heater when the alarm sounds (or lights up). Disconnect the power connection and
have the heater checked by a qualified electrician before reusing it.
•
To prevent possible fire, the space between the heater and the wall intended for the air inlet or
outlet must not be blocked in any way.
•
This heater has hot and sparking parts inside. Do not use in areas where petrol, paint or flam-
mable liquids are stored or used.
•
Use the heater only as described in this manual. Any other use than the one described in this
manual, is not recommended by the manufacturer and may result in fire, electric shock or per-
sonal injury.
•
Avoid using an extension cord as the extension cord may overheat and pose a potential fire
hazard.
•
To avoid overloading a circuit, the heater must not be connected to a circuit (e. g. multi socket)
to which other devices are already connected. Do not connect the heater below a socket.
•
It is normal for the plug to feel warm. However, a loose fit between the outlet (plug-socket) and
the plug can cause overheating and deformation of the plug. Contact a qualified electrician to
replace loose or worn sockets.
•
The performance of this heater can vary and the temperature can be so intense that skin can
burn. This heater is not recommended for people with reduced heat sensitivity or an inability to
react to burns.
Unpacking and Mounting to the Wall
Unpack the heater and the included equipment.
•
Mark the positions of the four holes on the wall. (The heater must be installed 0.2 m - 1.5 m
above the floor and 1.0 m below the ceiling).
•
Drill the holes from the accessory pack using the drill attachment.
•
Fit the extension tube (the side with arrows should be upside down) into the holes and fix it
with the screws (ST4 * 45 mm).
•
Mount the plastic fasteners (the side with the arrows should be upside down) to the four holes
of the panel radiator and tighten with screws (M5 * 8 mm).
•
Place the panel heater with the plastic fasteners in the extension pipes and tighten it with
screws (ST3 * 12 mm) on each side.
•
To uninstall the unit from the wall, use a screwdriver to loosen the screws only (ST3 * 12 mm)
that lock the plastic fasteners and extension tubes and then remove them.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 60259-60262
Seite 4
11
2020-1
Advertisement
Table of Contents
