Table of Contents
Advertisement
SA-WA10R
•
This set can be disassembled in the order shown below.
2-1.
DISASSEMBLY FLOW
SET
2-2. PANEL (SW) BOARD/
PANEL (FRONT) ASSY
(Page 4)
Note: Follow the disassembly procedure in the numerical order given.
2-2.
PANEL (SW) BOARD/PANEL (FRONT) ASSY
3 Insert the jig (Part No. J-2501-238-A) into a space and
raise the panel (front) assy gradually.
Note: When using a jig, please work so as not to
injure panel (front) assy and speaker box.
bottom side
six bosses
4 Raise the panel (front) assy a little by
little from bottom to top of the set.
4
SECTION 2
DISASSEMBLY
2-3. CHASSIS (NET) ASSY
(Page 5)
2 Insert a flat-head screwdriver
in the bottom of the set to raise
the panel (front) assy a little.
3 Insert the jig (Part No. J-2501-238-A)
into a space and raise the
panel (front) assy gradually.
Note: When using a jig, please
work so as not to injure
panel (front) assy and
speaker box.
2-4. REAR PANEL BLOCK
(Page 5)
2-5. POWER (SW) BOARD
(Page 6)
2-6. MAIN (SW) BOARD
(Page 6)
bottom side
1 two rubber foots (SW)
5 three screws
(BVTP3
8)
6 connector (CN603)
8 PANEL (SW) board
7 sheet (1)
1 two rubber foots (SW)
7 panel (front) assy
Advertisement
Table of Contents
