Table of Contents
Advertisement
Quick Links
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo
are trademarks of Anker Innovations Limited, registered in the United States and
other countries. All other trademarks are the property of their respective owners.
Model: T8910
51005002023 V01
User Manual
Motion Sensor
Advertisement
Table of Contents
Related Manuals for Anker EUFY T8910
Summary of Contents for Anker EUFY T8910
- Page 1 User Manual Motion Sensor Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are trademarks of Anker Innovations Limited, registered in the United States and other countries. All other trademarks are the property of their respective owners.
- Page 2 TABLE OF CONTENTS 02 10 What’s Included Specifications 03 11 Product Overview Notice 05 14 Mounting the Motion Sensor Customer Service English 01...
-
Page 3: What's Included
WHAT’S INCLUDED PRODUCT OVERVIEW For Motion Sensor Installation Battery Compartment LED Indicator Motion Sensor T8910 Mounting Screws User Manual Motion Sensor SYNC Button Installing Batteries Remove the battery compartment lid on the Motion Sensor and insert the provided Welcome Card CR123A Battery 3M Adhesive Strip CR123A battery. -
Page 4: Mounting The Motion Sensor
Adding Motion Sensor to Your System 3. The LED indicator turns solid blue to indicate the pairing is successful. LED Status Description Note: Make sure you've completed the setup of your eufy Security HomeBase. Blinking blue continuously Waiting to connect Solid blue for 5s Paired successfully Follow the onscreen instructions on the Eufy Security app to add your motion sensor. - Page 5 No Pets 20° You can also install the motion sensor in your garage, dining room, or basement. To better detect the area where people may break in, rotate the motion sensor Height and Tilt Angle horizontally up to 30º. The motion sensor should be mounted 2m / 6 ⁴ / ₇ ft to 2.5m / 8⅕ ft above the floor Sensitivity with a tilt angle of preferably 20º...
- Page 6 Mount the Motion Sensor 1. There are two methods of mounting the motion sensor at the selected location: • Use the 3M adhesive strip: ① Snap the adjustable wall mount onto the motion sensor base. ② Stick the adhesive strip on the back of the sensor, remove the film, and stick the motion sensor on the wall.
-
Page 7: Replace The Battery
Replace the Battery When the motion sensor’s battery is low, the LED indicator shows as below. ou should replace the battery to keep the motion sensor working. LED Status Description Blinking blue Movement detected while the HomeBase is connected Blinking red Movement detected while the HomeBase is not connected SPECIFICATIONS Battery: 1×... -
Page 8: Declaration Of Conformity
NOTICE Declaration of Conformity Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. FCC Statement For the declaration of conformity, visit www.eufylife.com. This device complies with Part 15 of the FCC Rules. Operation is subject to the... -
Page 9: Customer Service
RF. +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT) FCC ID: 2AOKB-T8910 IC: 23451-T8910 Anker Innovations Limited +44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT) Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00 Customer Support: support@eufylife.com...
Need help?
Do you have a question about the EUFY T8910 and is the answer not in the manual?
Questions and answers