Table of Contents
Advertisement
Quick Links
Amerec's PURE 2.0 control for the AX steamer
a wall, generally in or near the steam bath. It may be mounted directly on the wall surface either inside or outside
the steam room. The PURE 2.0 control may be used with another PURE 2.0 or with an Elite control, such as
when using one control inside the steam room and another outside it. You may use a total of 1 to 3 controls with
an AX steamer
Using the PURE 2.0, you set or adjust the steam bath duration and temperature and control a room light. Delayed
start settings allow you to have a steam bath ready to use in a few hours or on a regular schedule.
To reduce the risk of damage to the steamer or controls and to ensure the controls connect properly with the
steamer, always turn power off to the steamer before connecting or disconnecting a control.
Navigating the PURE 2.0
Indicators are used while navigating and setting the control.
A. Light: switches the lights on and off
B. Indicators for lights, door contact switch, delayed start, and to show whether the bath is on
C. Start Key: switches the bath on and off
D. Set/Change the Time or Temperature Value; LED indicates value on a 1 (low) to 10 (high) scale
E. Function Indicators: for temperature, delayed start, bath duration and humidity (not used with steam)
F. Function Selection
:
NOTE
the Pure 2.0's LED display show room temperature only.
Start Up
When the steamer power is turned on, some of the PURE 2.0's indicator lights (
control's program is starting, then they will stop. A red led at the right end of the indicator light group and one of
the #1-10 LEDs may turn on once the blinking stops. This will clear after a short wait or once bath Start (C) is
pressed.
It should take about 30 seconds to a minute for the PURE 2.0 to be ready to use. If an Elite is also connected, the
PURE 2.0 will not be ready to use until after the Elite has finished starting.
08/21/19
PURE 2.0 OPERATING INSTRUCTIONS
B
A
D
F
is a touch controlled unit intended to be mounted on
E
4211-1430
C
D
F
) will start blinking while the
B
Page 1 of 4
Advertisement
Table of Contents
Related Manuals for Amerec PURE 2.0
Summary of Contents for Amerec PURE 2.0
- Page 1 It should take about 30 seconds to a minute for the PURE 2.0 to be ready to use. If an Elite is also connected, the PURE 2.0 will not be ready to use until after the Elite has finished starting.
- Page 2 Initial Set-up If you are using an Elite with your PURE 2.0, you may use all the PURE 2.0 functions with the Elite but the Elite set-up should be done first. If you are using only a PURE 2.0, there are no set-ups required. The PURE 2.0 starts with the bath temperature set at 125°F (55°C) and the bath duration set at 60 minutes.
- Page 3 Installing the control Turn off power to the steamer. The PURE 2.0 connects to the AX steamer with a 50 ft (15,2 m) cable. The control cable must be plugged directly into the steamer circuit board using one of the four jacks in the middle of the circuit board.
- Page 4 Be sure to carefully level the control while mounting! Troubleshooting The PURE 2.0 has error displays to assist with troubleshooting. If an error should occur in the steamer or other equipment (PURE 2.0 control, temperature sensor, etc.) an error message will be shown using LED indicators.
Need help?
Do you have a question about the PURE 2.0 and is the answer not in the manual?
Questions and answers