National Instruments ER-8 User Manual page 62

Index
data acquisition system configuration
ER-8/16 configuration with DIO devices
(figure), 3-9
ER-8/16 configuration with
multifunction DAQ boards
(figure), 3-10
digital interface, 4-3
DIO-24 connector
pin assignments (figure), B-1
pin descriptions (table), B-2
DIO-24 devices
connecting to ER-8/16, 3-1 to 3-2
power supply (note), 3-3
DIO-32 boards
connecting to ER-8/16, 3-2
external power supply required
(note), 3-3
DIO-32 connector
pin assignments (figure), B-3
pin descriptions (table), B-4
documentation
conventions used in manual, x-xi
National Instruments
documentation, xi-xii
organization of manual, ix
E
environment specifications, A-2
equipment, optional, 1-2
ER-8/16
block diagram, 4-2
features, 1-1
getting started, 1-1
optional equipment, 1-2
software, 1-2
unpacking, 1-2
F
fax technical support, E-1
front connectors
exceeding maximum ratings
(warning), 3-1
for DIO-24 devices, 3-1 to 3-2
for DIO-32 boards, 3-2
ER-8/16 User Manual
fuses
description (table), 2-3
parts locator diagram, 2-2
replacing, 2-6
G
GND signal
26-pin internal connector
(table), B-5, B-6
DIO-24 connector (table), B-2
DIO-32 connector (table), B-4
I
inductive load, protection against.
See contact protection for inductive loads.
internal connectors, 3-7 to 3-8
26-pin internal connectors
pin assignments (figure), B-5
pin descriptions (table), B-5 to B-6
daisy chaining the ER-8/16, 3-8
I/O connectors. See also connectors.
26-pin internal connectors
pin assignments (figure), B-5
pin descriptions (table), B-5 to B-6
DIO-24 connector
pin assignments (figure), B-1
pin descriptions (table), B-2
DIO-32 connector
pin assignments (figure), B-3
pin descriptions (table), B-4
M
manual. See documentation.
O
operation of ER-8/16. See theory
of operation.
optional equipment, 1-2
Index-2 © National Instruments Corporation