Do you have a question about the SRV 9250BK and is the answer not in the manual?
Questions and answers
George Ioannou
March 21, 2025
sencor robor srv6450bk error message : move to flat surface
2 comments:
Mr. Anderson
March 21, 2025
The error message "move to flat surface" for the Sencor SRV 9250BK robot vacuum means that the device has detected an uneven or unstable surface. This could be due to the vacuum being stuck on an obstacle, a carpet edge, or an inclined surface. To resolve this, place the vacuum on a flat, stable floor and restart it.
This answer is automatically generated
George Ioannou
March 21, 2025
@Mr. Anderson the robot is sencor srv 6450 ai at open place no items near it
Robotic vacuum cleaner Important safety instructions READ CAREFULLY AND STORE FOR FUTURE USE. General warnings ■ This appliance may be used by children 8 years of age and older and by persons with physical or mental impairments or by inexperienced persons, if they are properly supervised or have been informed about how to use the product in a safe manner and understand the potential dangers.
from being excessively soiled during the cleaning cycle. When the vacuum cleaner Robotic vacuum cleaner finishes cleaning, it will automatically shut off the supply of water and thereby limit it leaking on to the floor. ■ For easy identification of the operating state, the button on the cover has an User's manual indicator light the colour of which indicates low battery voltage (lit red), battery charging (flashing alternately red and blue), full charge and operation (lit blue).
Page 9
SELECTING THE ROBOTIC VACUUM CLEANER CLEANING MODE INSERTING AND REPLACING BATTERIES IN THE REMOTE CONTROL ■ Push down the latch of cover C13 on the rear side of the remote control C1 to ■ Before starting the cleaning process, check that the entry door into your apartment release it and remove the cover.
■ Insert the dust container back into the water tank and insert this assembly back into charging current is exceeded, the charging station will automatically interrupt the the vacuum cleaner. charging cycle. ■ Start the vacuum cleaner. MANUAL CHARGING ■ If the vacuum cleaner is located away from the charging station and detects a low SCHEDULED CLEANING battery voltage then button D1 will be lit red.
This product meets all the basic requirements of EU directives related to SENCOR hereby declares that radio device model number SRV 9250BK is in compliance with directive 2014/53/EU. The full wording of the EU Declaration of Conformity is available at the website: www.sencor.eu.
Need help?
Do you have a question about the SRV 9250BK and is the answer not in the manual?
Questions and answers
sencor robor srv6450bk error message : move to flat surface
The error message "move to flat surface" for the Sencor SRV 9250BK robot vacuum means that the device has detected an uneven or unstable surface. This could be due to the vacuum being stuck on an obstacle, a carpet edge, or an inclined surface. To resolve this, place the vacuum on a flat, stable floor and restart it.
This answer is automatically generated
@Mr. Anderson the robot is sencor srv 6450 ai at open place no items near it