Table of Contents
Advertisement
Quick Links
EN
WLAN Interface SOL
for Solexa II control
Technical specifications and installation instructions
Item number 10154
Elsner Elektronik GmbH Control and Automation Engineering
Sohlengrund 16
75395 Ostelsheim
Germany
Phone +49 (0) 70 33 / 30 945-0 info@elsner-elektronik.de
Fax
+49 (0) 70 33 / 30 945-20 www.elsner-elektronik.de
Technical support: +49 (0) 70 33 / 30 945-250
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for elsner elektronik SOL
Summary of Contents for elsner elektronik SOL
- Page 1 WLAN Interface SOL for Solexa II control Technical specifications and installation instructions Item number 10154 Elsner Elektronik GmbH Control and Automation Engineering Sohlengrund 16 75395 Ostelsheim Phone +49 (0) 70 33 / 30 945-0 info@elsner-elektronik.de Germany +49 (0) 70 33 / 30 945-20 www.elsner-elektronik.de...
-
Page 2: Technical Specifications
Data from the Solexa II weather station is transferred to the app in the same way. The app can be installed on up to 6 mobile devices that can access the interface SOL simultaneously. Commands that are typed in (e.g. blinds up/down) are executed in suc- cession in the order of their arrival. -
Page 3: Notes On Mounting And Commissioning
Elsner Elektronik is not liable for any changes in norms and standards which may occur after publication of these operating instructions. 2.2. Prerequisites In order to be able to use the SOL interface following requirements must be fulfilled: • A mobile device must be available (smart phone or tablet) with the Android operating system 4.0.3 or higher or Apple iOS 8.0 or higher. - Page 4 3.2. Putting the SOL interface into operation The interface is plugged into a mains socket (CEE 7/4). The mains voltage must be 230 V AC / 50 Hz. Fig. 1 2 Reset key (recessed) SOL interface • Version: 24.11.2017 • Technical changes and errors excepted.
- Page 5 Initialising can take up to 1 minute. LED on WLAN configuration mode In order to be able to use the SOL WLAN interface, you must, first of all, configure the settings of the on-site WLAN (-> section configuring WLAN) Fig. 2 Screenshot of WLAN settings...
-
Page 6: Configuring The Wlan
3.3. Configuring the WLAN Prerequisite: The SOL interface status LED must be lit permanently. Call up the available WLAN networks on your mobile device. Select the "SOL WLAN interface" network. The mobile device is then connected with the SOL WLAN interface. -
Page 7: Operating The App
Press down the recessed reset button on the side of the device, next to the LED, with a pointed object for 5 seconds. Operating the app The app has two screens: Overview and Operating Screen. SOL interface • Version: 24.11.2017 • Technical changes and errors excepted. - Page 8 Change to the next/previous item by swiping to the left or right with your finger in the upper half of the screen. Switch to the overview screen with "< Overview" in the upper left of the menu bar. SOL interface • Version: 24.11.2017 • Technical changes and errors excepted.
- Page 9 For heating and lighting: current status (if applicable, level of dimming) • For sensors: current values 4 Weather data: • Rain (Yes/No) • Brightness • Wind speed • Outside temperature SOL interface • Version: 24.11.2017 • Technical changes and errors excepted.
Need help?
Do you have a question about the SOL and is the answer not in the manual?
Questions and answers