Electro-Harmonix OD GLOVE Quick Start Manual

FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class
Note:
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
OD GLOVE
Congratulations on your purchase of the OD Glove overdrive, a
versatile modern overdrive/distortion unit in a compact nano
enclosure. The OD Glove is capable of chunky high-gain distortion,
sweet overdrive, mild crunch, and even powerful clean-boost. An easy
to use but powerful tone control helps you dial in the right sound.
True-bypass switching keeps your original clean tone intact.
- CONTROLS -
GAIN Knob – Controls the amount of input gain and overdrive. As
you turn this knob clockwise, the OD GLOVE ranges from sweet
cleans to full-power distortion.
TONE Knob – The TONE knob on the OD GLOVE filters out high
frequencies. When fully clockwise, the full tonal range of the
overdrive comes through. As the knob is turned counter-clockwise,
high frequencies are rolled off. Use this to achieve a smoother tone or
to reduce any high-frequency harshness.
VOL Knob – Sets the output level of the OD GLOVE.
TONE SHIFT Switch – This switch controls the mid-frequency
emphasis of the TONE knob. Setting this switch to OFF creates a
flatter EQ, with some emphasis on low mids. Setting the SHIFT switch
to ON emphasizes mids and high mids. There is also a small increase
in volume when the switch is set to ON.
FOOTSWITCH and LED – The Footswitch selects whether the OD
GLOVE is engaged or in true bypass mode. When the effect is
engaged, the LED is lit.