Advertisement
Step 9
Refasten the lock bar to the rotary latch using
a screw and push nut on the opposite end.
Make sure the screw head is facing inward
towards the tool box to avoid interference.
Slide the lock bar into the lock bar support and
refasten the rotary latch to the tool box using
two screws and a screwdriver.
Step 10
Check the operation of the lock and latch.
The striker pin may need to be adjusted.
Reattach the lock bar guard with rivets
or screws of the appropriate size.
Step 11
CAUTION
Ensure all knobs, bolts, screws, straps and
locks are firmly secured before every trip.
Periodically re-tighten and inspect all components
for signs of wear, corrosion and fatigue.
With the truck side tool box installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Maintenance' section on page 1.
Congratulations on the installation
of your new UWS truck side tool box.
UWSTA.COM
•
NEED ASSISTANCE?
•
833.387.7720
•
RB
•
PAGE 4
Advertisement
