Advertisement
Step 5
If desired, the lock can be moved to the
opposite end of the tool box. If you are not
moving the lock continue to step 11.
Drill out and remove the rivets securing the
lock bar guard in place and remove the guard.
Step 6
Remove the two screws securing the rotary
latch in place. Slide the rotary latch and lock
bar out of the lock bar support.
Remove the push nut and screw securing the
lock bar to the rotary latch. If the push nut is
not reusable a lock nut can be used instead.
Step 7
Remove the hole plug in the side of the
tool box. Using pliers or a similar tool,
loosen the nut securing the lock in place.
Remove the lock.
Step 8
Adjust the position on the lock cam so it will
not make contact with the lock bar in the
locked position, and it will make contact
with the lock bar in the unlocked position.
Reinstall the lock on the opposite end
of the tool box. Reinstall the lock plug.
UWSTA.COM
•
NEED ASSISTANCE?
•
833.387.7720
•
RB
•
PAGE 3
Advertisement
