Acorn Superglide 130 User Manual page 25

26
9000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 25 9000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 25
DIGITAL DISPLAY CODES
NORMAL - Battery low
Bring the unit down to the nearest charging station. The unit
won't allow the user to travel in the UP direction until the
Key switch is in the OFF position
HARDWARE FAULT CODES
LIFT WILL NOT OPERATE
NORMAL - Safety grounded to chassis
NORMAL - Safety grounded to chassis
FAULT - Hinge communication fault
The stairlifts is failling to operate
the hinge section.
FAULT - Hinge end position not reached
The hinge section cannot get in line
with the rail or fully folded.
FATAL ERROR CODES
LIFT WILL NOT OPERATE
FAULT - Relay fault
FAULT - Brake fault
Acorn Stairlifts User Manual
• Activate the
directional toggle
switch and drive
the stairlift to a
charge point
• Check that the
key is in and
turned to the
ON position
4
• Check continuity
between every
switch in the SW1 or
SW2 safety circuit
and chassis
•
Check that the mains
supply has not been
from the wall.
•
Contact your authorized
Acorn dealer for
assistance
•
Check for obstructions
around the hinge
section.
•
Contact your
authorized Acorn
dealer for assistance
5
• Reset the stairlift
seconds)
• If not resolved,
contact your
authorized Acorn
dealer for assistance
• Reset the stairlift
seconds)
• Drive the stairlift to a
charge point, and leave
to charge for one hour
• If not resolved, contact
your authorized Acorn
dealer for assistance
2/10/2021 10:45:02 AM 2/10/2021 10:45:02 AM