Related Manuals for Network Thermostat NetX NT-URS
Summary of Contents for Network Thermostat NetX NT-URS
- Page 2 Sensor Counting Example 1: sensor. Install the wires in the terminals using the table You are connecting an INDOOR sensor, OUTDOOR sensor, from Network Thermostat Install the NT-URS sensor using the single sensor instructions. below. AUX1, and AUX2. The sensor count is 4 and the correct jumper configuration is the middle jumper 3-5.
- Page 3 2.1”H x 2.85”W x 1.0”D (53mm x 73mm x 25.4mm) A NOTE: In this condition, the NT-URS will stop reporting until Approved Cable Types: Network Thermostat™ warrants to the original purchaser that the communication with the external probe is fixed. CAT5 or CAT5e unshielded, or 1-Pair Twisted Shielded Cable this product will be free from defects in workmanship and with Drain and nominal capacitance of 12pF/ft or less.
- Page 4 WIRING DIAGRAM COMPATIBILITY CHART To Thermostat RS2 RS+V RS1 Multiple Configurations for Flexible Application Use UP32 US32 NT-URS Wiring Instructions ● Only 1 Sensor for each type per thermostat except for INDOOR Sensor • • • ● All non indoor sensors and 1 INDOOR sensor wired to RS1-to-RS1, RS2-to-RS2 and RS+V-to-RS+V NT-URS INDOOR TEMPERATURE &...