Table of Contents
Advertisement
6.
Vetter High Pressure Leak Sealing System
6.1
Description
The high pressure leak sealing system consists of one or three sealing
hoses, depending on the version. This is intended for sealing T-pieces,
pipe bends or problematic connection supports.
Additional sealing plates made of different materials (NBR, EPDM, glass
fibre reinforced plastic) produce a higher resistance.
6.2
Safety instructions
Observe the pertinent regulations for work safety. Danger of
explosion! If there are inflammable liquid or gas leaks it is im-
perative that sparks be avoided by fixtures and fittings.
6.3
Ground connection
9 The inflation valve as well as couplings and joints on the sealing ho-
ses and on the inflation hose are made of stainless steel.
9 The sealing hoses are conductive and equipped with a grounding
device on both sides.
9 Fix the ground cable onto the grounding device attached to the
sealing hose.
9 Secure the ground cable hand-tight using the wing nut.
9 Before use, check to see whether the high pressure leak sealing sys-
tem is resistant against hazardous materials.
9 Wear specified protective clothing necessary for operation
Page 15/39
Advertisement
Table of Contents
